Template for the Supercomputing Frontiers and Innovations journal.
This template was originally published on ShareLaTeX and subsequently moved to Overleaf in November 2019.
\documentclass{superfri}
% ------------
\bibliographystyle{plain}
\begin{document}
%\classify{MSC?}
\author{I.M.~Scientist\footnote{\label{susu}South Ural State University}, U.R.~Author\footnoteref{susu}}
\title{SuperFri article template}
\maketitle{}
\begin{abstract}%
This template is devoted to helping you format your article the proper way in
\LaTeX.
\keywords{superfri, template, article formatting}
\end{abstract}
% -----------------------------------------------------------------------
\section*{Introduction}
\label{sec:intro}
The template demonstrates how to use the \emph{superfri} class. It could be
used as a basis for your article and meets all the formatting requirements of
the SuperFri journal. Consult the author
guidelines\footnote{\url{http://superfri.susu.ac.ru/superfri/about/submissions#authorGuidelines}}
for details on that matter.
\section{The class}
\subsection{Installation}
The class consists of a single file \verb=superfri.cls= which should reside
along with your manuscript file.
\subsection{Features}
The class is based on the standard article class and supports all of its
features, as well as these:
\begin{itemize}
\item title and author formatting;
\item abstract and keywords;
\item theorems, definitions, and proofs.
\end{itemize}
Begin your paper with the title and authors' names. After filling the
necessary info in with \verb=\title= and \verb=\author= commands put it all
together using the \verb=\maketitle= command.
Define the structure of your article using up to three levels of nesting with
the \verb=\section=, \verb=\subsection=, and \verb=\subsubsection= commands.
You can use the environments \verb=theorem=, \verb=proof=, \verb=lemma=, etc.
Here are two sample references:
\cite{Cadez:2000:VNP:347090.347151,Stonebraker:1994:PND:190956.191247}.
For further directions read the comments in \verb=superfri.cls= as a manual.
\subsubsection{Subsubsection title}
The equations look like
\begin{equation}
a^2 + b^2 = c^2 + \int_1^2 x+y \, \mathrm{d}y,
\end{equation}
where $2$ is a number.
An example of a figure is shown in~\figref{pic-myfigure}, while a table
is in~\tabref{tab-mytable}.
\fig{width=5cm}{pic-myfigure}{An example of a figure}
\tab{tab-mytable}{An example of a table}{
\begin{tabular}{rcl}
\hline
one & two & three \\
\hline
a & b & c \\
$\alpha$ & $\beta$ & $\gamma$ \\
$x$ & $y$ & $z$ \\
\hline
\end{tabular}
}
\ack{Put the acknowledgements after the last section, like this.}
\bibliography{template}
%\received{September 25, 2013}
\end{document}